Nibal,

I created an identical Drip Ring, yet it shows the same 1.7 lpm.
I don't know if the equipment was replaced, or edited, or the units changed, or what, but clearly something was done other than simply creating the drip ring, placing it, and editing it. Any information you can give us on what you did would be very helpful.

--J

Dear Jeremiah,

Thank you for the reply..


Actually, I added the Drip Ring as new equipment to the irrigation manager.
and suddenly, when I was sizing the connected valves I noticed that flow rate of the valve is very high.

I don't really remember if I did something in specific caused this.

To fix the issue, I deleted the equipment from the irrigation manager , purged and then add it again.\\and then everything worked fine.

Nibal