By Julie Riddle on Friday, 16 April 2021
Posted in Irrigation
Replies 1
Likes 0
Views 2.3K
Votes 0

Hey all,

Since you made the change to docking the Irrigation Manager, it's created another change. Before, I'd select an item from the ribbon at top (ie drip line, lateral line, sleeve) and when I was done drawing it I'd hit ESC, then ENTER to re-initiate the command and start drawing in another location of the plan.  This still works when you use the ribbon to select your item.

However, it does not work when selecting an item in the docked Irrigation Manager.  Select the item item in Irrigation Manager, click PLACE, ESC to finish the command. In order to restart the command you have to select the item again in Irrigation Manager, you cannot hit Enter.  I've abandoned the Irrigation Manager and un-dock it and close it every time I open a drawing because it takes a lot of space and I use the ribbon instead so I can use ENTER to restart the command.  When I need it I just open using the Irrigation button in the ribbon as before.

Also, I haven't been able to make the Irrigation Manager window, when docked, any narrower (green arrow).  My screens aren't small but it literally takes up at least a 1/4 of my drawing space... Can you help with that?

Thanks!

Julie

Julie,

 

For the new Circuiting palette, we came up with a way for right-click repeat support.  I'll get this noted to apply to the Irrigation palette as well.

 

As for the width, that is the minimum width, but you can configure it to auto-hide:

https://www.landfx.com/docs/planting/planting-getting-started/item/2338-docking.html

 

--J

·
3 years ago
·
0 Likes
·
1 Votes
·
0 Comments
·
View Full Post