I am having an issue where I placed Turf sprays using a 6" pop-up and shrub sprays using a 12" pop-up and they do not show up that way in the Irrigation Schedule.
The 'Special Sprays" (corner strip etc) show up in the legend with the right pop up, but the rest all show up as Turf Sprays using the 6" pop-up even though the data for the Shrub sprays shows them using the 12" pop-up.
Any help would be greatly appreciated, thank you!
The 'Special Sprays" (corner strip etc) show up in the legend with the right pop up, but the rest all show up as Turf Sprays using the 6" pop-up even though the data for the Shrub sprays shows them using the 12" pop-up.
Any help would be greatly appreciated, thank you!
Mark,
If you go into your irrigation preferences you will probably see that you have the same symbol family selected for both your turf and shrub spray types. Change one of the symbol classes to another symbol family and click ok. From here you can use the edit equipment button and click on one of the symbols you made the symbol change for and click the replace button. Select the same model that you previously had assigned and you should see all heads change to the new symbol family.
As always, you are welcome to use our ticket support system to send in you file so we can take a look as well.
If you go into your irrigation preferences you will probably see that you have the same symbol family selected for both your turf and shrub spray types. Change one of the symbol classes to another symbol family and click ok. From here you can use the edit equipment button and click on one of the symbols you made the symbol change for and click the replace button. Select the same model that you previously had assigned and you should see all heads change to the new symbol family.
As always, you are welcome to use our ticket support system to send in you file so we can take a look as well.
Mark,
If you go into your irrigation preferences you will probably see that you have the same symbol family selected for both your turf and shrub spray types. Change one of the symbol classes to another symbol family and click ok. From here you can use the edit equipment button and click on one of the symbols you made the symbol change for and click the replace button. Select the same model that you previously had assigned and you should see all heads change to the new symbol family.
As always, you are welcome to use our ticket support system to send in you file so we can take a look as well.
If you go into your irrigation preferences you will probably see that you have the same symbol family selected for both your turf and shrub spray types. Change one of the symbol classes to another symbol family and click ok. From here you can use the edit equipment button and click on one of the symbols you made the symbol change for and click the replace button. Select the same model that you previously had assigned and you should see all heads change to the new symbol family.
As always, you are welcome to use our ticket support system to send in you file so we can take a look as well.
Thank you! It took a few tries to make the symbols switch properly, but they did.
Forgot to mention that in irrigation preferences, there were different families assigned to Turf and Shrub heads already, yet they all displayed as the same family. I went in and switched them around, then switched them back to what I wanted and that worked.
- Page :
- 1
There are no replies made for this post yet.
Contact
- Land F/X
Our software tailors AutoCAD® to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.