Hello,
A client has requested 2 quick couplers for a project. I have created and located the POC, backflow device, quick couplers, and the main line. When I attempt to size the main line, I receive the following message, "No connected valves. Check the status of any Shut Off Valves, and run the Verify Mainline." Land FX sizes the pipe between the POC and the backflow device, but none of the other mainline segments.
What is the best method to size the mainline for these quick couplers?
Thanks,
Doug
A client has requested 2 quick couplers for a project. I have created and located the POC, backflow device, quick couplers, and the main line. When I attempt to size the main line, I receive the following message, "No connected valves. Check the status of any Shut Off Valves, and run the Verify Mainline." Land FX sizes the pipe between the POC and the backflow device, but none of the other mainline segments.
What is the best method to size the mainline for these quick couplers?
Thanks,
Doug
The system is assuming that you have some sort of demand, so it will see only quick couplers as a mistake.
You can drop in a Cap to generate some demand, and it will then size the whole system.
--J
You can drop in a Cap to generate some demand, and it will then size the whole system.
--J
- Page :
- 1
There are no replies made for this post yet.
Contact
- Land F/X
Our software tailors AutoCAD® to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.