I have a question that may be partially related to the question I asked last week about Northing Easting Point Schedules. See link: Title
I'm doing something fairly unconventional with the northing/easting points in that I'm using them with architectural units. This may be part of my problem. Without going in to great detail about why I'm doing that, I will say that the project is very small (3000 SF), but with reasonably complex geometry that would render the plan illegible with the number of dimensions required. Most of the small-time contractors around here have some difficulty with decimal units for site measurements, so that's why I'm using architectural.
Anyway, what I am finding is that when I try to insert a Northing/Easting Callout from the Site Callouts (block = LAFX-NORTHEAST), the linework appears, but no text. If I double-click the block, the "enhanced attribute editor" opens and I can select text options and see that no text style is applied to the block. If then I select "Callout Light" for each attribute, the text appears as it should. But each time I insert a new instance at a new location I have to do this exercise. I've tried deleting all instances of the block from my drawing, purging, and starting over -- no luck. Where have I gone wrong and what might I try to rectify this?
Thanks in advance for your help!
I'm doing something fairly unconventional with the northing/easting points in that I'm using them with architectural units. This may be part of my problem. Without going in to great detail about why I'm doing that, I will say that the project is very small (3000 SF), but with reasonably complex geometry that would render the plan illegible with the number of dimensions required. Most of the small-time contractors around here have some difficulty with decimal units for site measurements, so that's why I'm using architectural.
Anyway, what I am finding is that when I try to insert a Northing/Easting Callout from the Site Callouts (block = LAFX-NORTHEAST), the linework appears, but no text. If I double-click the block, the "enhanced attribute editor" opens and I can select text options and see that no text style is applied to the block. If then I select "Callout Light" for each attribute, the text appears as it should. But each time I insert a new instance at a new location I have to do this exercise. I've tried deleting all instances of the block from my drawing, purging, and starting over -- no luck. Where have I gone wrong and what might I try to rectify this?
Thanks in advance for your help!