Repair POLYDIVIDE changes to drip hatch angle
By Julie Riddle on Tuesday, 18 May 2021
Posted in Irrigation
Replies 4
Likes 0
Views 2.3K
Votes 0

I used POLYDIVIDE to split a drip area in two, and now the hatch is at 45 degrees from the direction I need it on the top half and -45 on the bottom half!  It used to be that I could manually change the angle using MO or hatch editor, but it's no longer working (admittedly it's been a long time since I've done it).  How can I adjust it?

Thanks!

Julie

Well something is obviously off with that hatch.

An AUDIT might repair something.   But at this point, it would be quickest to just delete and re-place it.

 

--J

Jeremiah Farmer
·
3 years ago
·
0 Likes
·
0 Votes
·
0 Comments
·

Julie,

 

In the screenshot, the Properties palette shows the hatch angle at 0.  You should be be able to change it there.

 

--J

Jeremiah Farmer
·
3 years ago
·
0 Likes
·
0 Votes
·
0 Comments
·

It throws an error unfortunately.  Check out my screencast video: https://www.screencast.com/t/BpwcAiRWgP

Julie Riddle
·
3 years ago
·
0 Likes
·
0 Votes
·
0 Comments
·

Will delete and replace :) Thanks for your time!

Julie Riddle
·
3 years ago
·
0 Likes
·
0 Votes
·
0 Comments
·
View Full Post