VALVE SCHEDULE
By Nibal Ata on Tuesday, 15 October 2024
Posted in Irrigation
Replies 3
Likes 1
Views 580
Votes 0
Good day,

when I regenerate the valve schedule I noticed that it increases the header height as shown in the attached.
I need to do a new valve schedule to keep the standard height of the header or adjust the valve schedule block.
Hi Nibal,
Cole here with Land F/X. When we looked at your files, it appeared that the Valve Schedule block in the drawing was incorrectly defined. This could have happened by copying a Valve Schedule from another drawing, accidentally changing the title text vertex location, or something else of the sort. To resolve this, delete the valve schedule(s) from your drawing, type the command PRG, and hit enter. After this, you will be able to place a correct Valve Schedule. Let us know if you have any further questions.
Cole
·
1 month ago
·
1 Likes
·
0 Votes
·
0 Comments
·
Hey Nibal, Jesse with the Land F/X irrigation team here. Thanks for reaching out about that. I'll start a ticket for you so you can send your files. We will need the files to look into this for you. I'll make sure we summarize the ticket back on this post.
Jesse Conner
·
1 month ago
·
1 Likes
·
0 Votes
·
0 Comments
·
Thank you Jesse and cole,

I did delete the valve schedule from the drawing, then purged it and could be able to place a correct Valve Schedule.

Regards,
Nibal
Nibal Ata
·
3 weeks ago
·
1 Likes
·
0 Votes
·
0 Comments
·
View Full Post