Hello,
A client has requested 2 quick couplers for a project. I have created and located the POC, backflow device, quick couplers, and the main line. When I attempt to size the main line, I receive the following message, "No connected valves. Check the status of any Shut Off Valves, and run the Verify Mainline." Land FX sizes the pipe between the POC and the backflow device, but none of the other mainline segments.
What is the best method to size the mainline for these quick couplers?
Thanks,
Doug
A client has requested 2 quick couplers for a project. I have created and located the POC, backflow device, quick couplers, and the main line. When I attempt to size the main line, I receive the following message, "No connected valves. Check the status of any Shut Off Valves, and run the Verify Mainline." Land FX sizes the pipe between the POC and the backflow device, but none of the other mainline segments.
What is the best method to size the mainline for these quick couplers?
Thanks,
Doug