Friday, 27 April 2018
  5 Replies
  3.5K Visits
1
Votes
Undo
Is there a way to "Replace" all placed Drip Control Zone Kit (valves) with standard remote control valves. The "Replace" button in the Edit Equipment pop-up for the drip control kit takes you to other drip control zone equipment in the Manufacturer Connection dialogue.

We mistakenly placed Drip control zone kits in our project and due to the low starting pressures at the point of connection the pressure reducers in the Zone control kits increase the existing pressure deficiency. Instead we wish to place stnadard valves with filters to eliminate the pressure reducers. Hoping for a quick replacement versus having to delete whole stations.

Thank you,
    
6 years ago
·
#2196
Accepted Answer
3
Votes
Undo
Daniel,
Most definitely! Use our Match Properties tool. I have provided a few links that will guide you through how to do this. Please let us know if you have any further questions we can help you out with.

Match Properties – Irrigation

Power Tip: Match Properties Window Selection
6 years ago
·
#2196
Accepted Answer
3
Votes
Undo
Daniel,
Most definitely! Use our Match Properties tool. I have provided a few links that will guide you through how to do this. Please let us know if you have any further questions we can help you out with.

Match Properties – Irrigation

Power Tip: Match Properties Window Selection
Great. Thank you. :D Works like a charm except the new valves are no longer connected to the last leg of lateral line after replacement. Is this to be expected? I assume I just delete and replace that segment of lateral?
6 years ago
·
#2202
0
Votes
Undo
Hmmm, things should stay connected for sure. I just did a test on my side and things stayed connected. If your pipes did indeed get disconnected, please send in your files via a support ticket and we can see what may be going on. But yes, deleting and replacing the segment would get it back up to par, however, we don't want that to be the norm as things should stay connected so you don't have to do that every time.

How to Submit a Technical Support Ticket
Jake,

My apologies. My reading of the valves as disconnected was based on interpretation of Mainline Verification results and graphic representation of the lateral/valve connection (I expected a fitting circle to be visible). Further investigation revealed that re-sizing the laterals resolved the Mainline verification errors.
6 years ago
·
#2204
0
Votes
Undo
Awesome! Glad it was working then! :D

Please let us know if you have any further questions that we can help with.
  • Page :
  • 1
There are no replies made for this post yet.