Good afternoon all,
I need to ask a question about the bad argument "Stirngp nil".
I come up with this each time am trying to place a remote control valve just today, however I placed one few days ago and everything went fine.
I went through the documentation in regard with this error, and
1- I did clean up the advised drawing along side with the other xrefs,
2- I did deleted the equipment and install new one,
3- I did try to place the equipment in a blank drawing
but still getting the same error
Is there anything else I can do? or is it a bug?
Thanks in advance
Nibal
Nibal,
That was indeed a bug. Apologies, I hope it didn't slow you down too much. Placing from the ribbon still would have worked, it was only placing from the Manager that was broken.
I have posted an update that addresses the issue.
--J
Nibal,
That was indeed a bug. Apologies, I hope it didn't slow you down too much. Placing from the ribbon still would have worked, it was only placing from the Manager that was broken.
I have posted an update that addresses the issue.
--J
- Page :
- 1
Contact
- Land F/X
Our software tailors AutoCAD® to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.