I was looking in preferences, but couldn't find where to assign the layer for FXrefattach. It\s coming in on layer Z-REFR. Stantec uses G-REFR. Where can we make that change?
Steve Cook
set the type of the post as
Issue — 9 months ago
Steve,
Our default is actually "Z-XREF", so someone must have changed this layer already. In your office Preference Set (General Tab), under the layers section, you should be able to navigate to "Z-REFR" and select that layer from the list and click Edit. Make your name change to "G-REFR" and say ok. This should then apply the new layer when fxREF is run.
Our default is actually "Z-XREF", so someone must have changed this layer already. In your office Preference Set (General Tab), under the layers section, you should be able to navigate to "Z-REFR" and select that layer from the list and click Edit. Make your name change to "G-REFR" and say ok. This should then apply the new layer when fxREF is run.
- Page :
- 1
There are no replies made for this post yet.
Contact
- Land F/X
Our software tailors AutoCAD® to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.