I am adding spot elevations from the existing grades at my site. Would it be best to put those on their own DWG instead of putting them right on the base map?
I plan to send them to SketchUp and then make contours that I can send back to LFX.
<--- This is where I paste a photo of me with a sheepish look. Yep. It was there all along. Very tiny because I hadn't set the scale.
But just to confirm, YES, I should make those spot elevations on a separate DWG. That way, it will be easier to create a digital elevation model in SketchUp.
Thanks!
David,
Are you sure the elevation is just not very, very tiny? It could be that you have not set a scale.
--J
Yes. I watched that and have done it with other drawings successfully.
However, in this job, I haven't added the spot elevations yet. When I try to add them to my Xref'd base map. I get an Mleader, but no elevation.
I think I may have answered my own question, because I see that I can't add spot els to an Xref. Or can I? What happens is I specify the point and it gives me a leader, but there's no elevation.
- Page :
- 1
Contact
- Land F/X
Our software tailors AutoCAD® to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.